UPS brought me presents:

2ftx4ft sheet of 1/8" 3003 aluminum to make my dual electric fan shroud:




Borla muffler, was planning on using 4.5" tubing to add a tip to it, possibly with a 3.5" -> 4.5" cone transition, but starting to think it may look silly with the tip only being .5" dia smaller than the muffler case itself.



After that stuff showed up, went to pep boys to grab my lh Z32 tt axle to replace the one that was wrong from before, only to find out its 30 spline again, i'd just go get the used one at z fever, if it wasnt for doug trying to buy a big fat crack rock, or some good pot with my money, wanting $125 for a used axle.