I have a good eprom i just bought tuned by jestr tuning in orlando. I just need to make sure all the wires are ok under the hood. since its a 6 bolt motor and a 95 eprom ecu would i need to change the firing order? what should the firing order look like on the head and on the coil pack? Thanks for the replys
(would this sound right?) Found this post off of dsm tuners

OK, ### you should do is make sure your timing is right.
Next you use arange the wires in
4123
and the block cylinder order is
4321.

the order for the wires switches as follows.
4 with 2 and 1 with 3.
the new order is
2341.
and you're all done.
and all you need is to start'er up and good to go.