Trying to figure this out, I had decided to bleed my clutch today, the clutch didn't feel as tight as it used to but it wasn't all that bad, and working fine. Well I go to bleed it by these basic steps.

-Pump a few times, hold down
-Release the bleeder
-Close the bleeder
-Pump a few times, hold down
-etc

Well I got rid of some air but I never get the pressure back, just stays to the ground, I thought of the Master Cylinder but it was working just fine before I attempted bleeding :/ Sucks because I need the car for work tomorrow and I can't drive it now! lol

Hoping to get some help on what else I can do besides replacing parts, hoping to avoid that