Chassis stiffening via various methods...
Looked like a good topic in the "What did you do..." thread and I have a few more questions. Rather then clog up the other thread I figured I would make a new one to gather all the info.
Now with the expanding foam, looks like they drilled holes in the rocker to fill it. Is that the only way to get it in there or is there another way to fill it? Will the foam also fill the crevices on either side of the rear seats? I am looking to isolate the cabin acoustically and seems easier and cheaper then roll after roll of Dyna-mat. Plus the rigidity is an added bonus.
And Epstein, if you were looking for stiffness why not go with the 16lb setup?
Also, what are the fire properties of the foam you used Epstein?
Last edited by Ph34r; 07-15-2009 at 07:48 AM.