These are the new wires that im putting in.

These are 8 AWG wires, Oxygen Free, Oil resistant sheath, Ultra Fine strand, multitwist. these are actually Stereo Amplifier cables that are intended to supply 45+ Amp's of current @ 13.7v, rated for Amplifiers of 600+ Watts of continuous power. These wires barely fit into the Yellow crimp connectors. i Used Female blade connectors since the Fuel pump has Male blade connectors. Obviously, i put the Red wire on the + side and the Black wire on the - side.

I was going to put these blade connectors into the stock harness connector, except these wires were Entirely too large to fit inside that connector. You can see the Yellow insulation that i had to cut off the female blade connectors so that it would actually fit into the female recepticle of the fuel pump connector; i just split it down the side, spread them apart, and slid them off. I only stripped ~3/8" of insulation off the cables and crimped the now-bare female blade connectors onto the cables.