Originally Posted by
Epstein
The way I read it was that the Altima rotors were needed so they don't hit the swaybar mount. And that they're only 2mm different than mile-o-washers Q45 rotor setup. Going to LKQ tomorrow to check it out.
This is the follow up that I mentioned on an S14 with Z31/Altima rotors done last month noting that they fit with out the use of washers.
http://www.freshalloy.com/forums/sho...d.php?t=192682
See if they have two sets, I'll give you a finders fee if you can get me a pair.
And I dont remember it making a weird noise. It might have, I just have alot going on so I forget if it made funny noises. But the motor is still overly tight. I can get it to run but I have to rotate it by hand past TDC to get it to start. My starter started to smoke because of the strain.