i've used a felpro (oem like) gasket twice now on builds. works very well. you won't need anything else, except an extra set of hands. easiest way is to have a buddy hold the head up while you aline atleast two head bolts. after that just drop the head on, sandwiching the gasket in place. (also make sure you see the silver "UP" laying up and facing the back of the motor) once you get it on torque the head bolts inside to outside, so you start from the inner most and work your way to the outter most bolts in a circle. start with 25ft/lbs the step it up after all have been tightened by 10ft/lbs at a time, till you get to 75ft/lbs. honda gaskets don't require the use of a "gasket adhearing material" and are actually reusable if they are in good shape! lmk if this helps.