Got the carb fitment squared away. Had to notch one of the heat sinks to allow the throttle linkage to move to full throttle. Done. Installed; rock and roll.

Fixed the nitrous solenoid / AED throttle cable fitment issue as well. Bought the 1" spacer from MikeyP, and then just bent the nitrous manifold a slight bit to get the solenoid to clear the bracket. Done, installed, rock and roll.

Got all that done, and bought a few more little odds and ends for the car. Still needing to pickup a few pieces to finish it... Should be able to get running though in April. Going to try and sell or trade down to raise capital for the company most likely.