Originally Posted by
MiDiablo
[*]Comp Cams XFI Nitrous Cam (.579 lift)
Comp Cams Part number 35-775-8 Cam Grind Number XFI1236HR-14
Originally Posted by Comp Cams Catalog
HYDRAULIC ROLLER-347CI or Larger. Super strong mid range. Best with/ 9.5 to 1+ compression, aftermarket heads, intake, T-body & injectors. 2800+ stall speed or 5 speed. Computer mods a must. RPM Operating Range 2600-6300
Josh most after market heads come with around a 64cc chamber, Do you know what size cc dish your piston is. Not the cc of the valve relief, but the cc of the dish. I knew this was Adam's old motor but I don't think I knew he had a "dish" piston.
Again if your going to do a blow through set up some time down the road. I would try to find the heads that would work best for it, rather then what would work best for you now. It will save you time and money down the road.
If you don't plan on doing the blow through set up for a while. Then I would try to keep the compression up. If you were going to do the blow though obviously you would need less compression. Plus that camshaft really wouldn't be ideal for a blow though setup. Something like that I would have custom ground.
Are you sure that stall is that big?? So if that is a 5000 stall and your cam makes power from 2600-6300...... I don't think that is matched well at all.
but for the question here at hand, I think an AFR 185 would be a bad ass head for your setup. It may be on the tad big side but nothing the spray won't make up for. I had awesome luck with my AFR's. You can't go wrong with them thats for sure!!
Keep an open mind and just look to see whats out there. With the internets, there is always someone stepping up and wanting to get rid of their old setup.