I just got a skunk2 intake manifold and removed my stock intake manifold. I then removed the stock throttle body from the stock IM and tried to bolt it up to the new skunk2. There were 2 screws and 2 nuts that held the TB to the stock IM. There are 4 screw holes in the skunk2 IM. How am I suppose to fit the stock TB on the skunk2? Not everything that was on the old IM will be able to fit onto the skunk2. What am I suppose to do? Should I just get a new TB? If so which one should I get? I have a 98 GSR with crower cams (63402) and crower valve train. I also have fuel upgrades using 310 cc RC injectors and a walbro fuel pump. My ignition is bumped up using an MSD SCI-L ignition, with blaster 2 coil, and NGK spark plug wires. I am also running a 50 shot nitrous kit. Again, what should I do. Any info would be greatly appreciated. Thanks