well i took my 2.0 motor out without th tranny, i then poped the tranny out and left the axels bolted into the hub. i put the new motor botled to the transmission in and was able to slide the driver side axel back in (seperated at the joint), now the passenger side axel is still connected at the hub but other end is right below the where it needs to go into. my other neon i took out the bolt in the center of the wheel then took off the spindle and did it that way but i can NOT get the center bolt off, i used and broke a socket with 4ft pry bar and a impack gun it still hasnt moved an ince... anyone have suggestions? this is the only thing now keeping my car from hitting the road