Garrett t3/t4 .57trim stg3 .63 a/r. Turbine side 2000* painted and cured. Compressor side sanded and painted copper. No shaft play. I never used this turbo, but it was run by Mtber before me. I have no idea if it smokes or not. This is a 4 bolt turbine housing.


Log mani flanged for tial WG. No WG included. WILL include dumptube! Dumptube was previously coated.

Downpipe, 4bolt. Has 2 bungs for o2 sensors, and a flex pipe. This was also previously coated. I touched up a little bit with the 2000* paint. This is a full downpipe, from turbo back to just behind the motor, 2.5"

A/C and POWER STEERING COMPATIBLE. Notching of the block is required. This setup was purchased from Mtber a couple months ago, and I never used it. It was previously used.

$600 picked up, bradenton area.Pictures upon request.