why is bi lo shady? I've never had a problem with them. You just have to tell them exactly what you are wanting and when you need it. They will get it done.

Powerhouse took some 4g63 7 bolt rods and made them work on our 6 bolt crank. Basically all it requires is machining the crank end sides of the rod down. They gouged the sides and didn't bother to debur anything. The block was bored 20 over and was not consistent. 3.375 in some places up to 3.386 in others. They had the pistons and the block girdle there to check everything and still managed to mess it up.

Very disappointing in my opinion