Originally Posted by
kbcobra
What's the difference in width? I don't want to go narrower. Cat back exhaust would be included in the trade. As far as I know, I still have the stock gears, which I believe are 3.27s (I'm the 3rd owner of the car, I'm confident that the guy I bought if off of didn't do gears, but I'm not sure about the original owner).
Any '99 - '04 owners out there looking to swap? GT's or Mach's only please!
Stock 99+ Cobra gear (IIRC) should be 3.55
Yes the 96-98 axle is 3/4 inch narrower on each side.
This does not effect the interchangability. They both bolt to each other.
If you run 17x8 or 17x9 wheels then you'll notice a slight gap between the fender and edge of tire. 17x10.5 fit nicely. I run 17x10.5 on mine.
For perfect width your better off with a 99+ GT or Mach1 axle housing. How ever,.. with 96 - 98 rear you could get away with smaller wheel offset that you couldnt do with 99+ solid rear. For example,.. a 17x12 wheel will fit with the quad shocks removed. You can not do this with 99+ axle.
Hurst