5zigen Fireball Used. Looks like maybe for Honda hatch?? Can be welded to anything. 2.5" inlet, 3.5" out, still has about 1' of straight piping with 2-bolt flange and some hangar. No chunks of rust or cracks $100 obo, PM me if you want it installed (welded on).




Grenade shift knob Made from a real grenade, pin ring tack-welded in to prevent rattling. Subau and Toyota shifter pattern. I made it, so good luck finding another one. If you know the pitch of your shifter, I'll weld on the right nut for you for an extra $5. As is $30 neg.




Subaru WRX strut bar Used. looks like STi or knockoff. Aluminum center and steel plates. $25 obo.



Subaru WRX/Impreza trunk triangulation bars Look to be Cusco. Installed once, these tie the strut towers to the trunk floor. There is 1 additional bracket that goes with this, but I forgot to bring it home to take a picture of it. Could easily be modified to fit another car. I don't know what these are worth, asking $30 neg.


ATE Super Blue DOT 4 brake fluid Bottle says "Original Bremsflussigkeit" 1 liter can that I used no more than 100ml out of (90% or more is still in the can). This will be more than enough to flush and fill an entire brake system on a S14 with 300ZX brakes front and rear. Blue coloring helps spot leaks. $20 firm (was $45 new)





OBX fuel pressure regulator No gauge or fittings, just the regulator. Used. $40 firm



Autometer Air/Fuel gauge bought from a friend, never installed. It's been installed before, wires are cut but have plenty of length left for future installation. Still works to my knowledge. Comes with sweet A-pillar single pod. $20 firm



4-inch to 5.75" Bellmouth Would look awesome on the front of a turbo or as a, Intake or brake duct. Never installed. $25/make offer



PM me here, email me at mranlet@tmail.com or text message me at 9.4.1.2.2.4.7.2.3.5
Thanks for looking!