Yeah,a little too much money and waaaaaay too much time.My girlfriend would like nothing more than to sell the car wile I'm at work.
I started this project in the summer of 06'.Since than I've invested roughly $48K into the car.I could have had it done a lot sooner but I spared no expenses with this car.The best of everything was used in this build.
*Shep Dogbox
*Tilton Carbon/Carbon clutch
*DSS Stg.5 axles
*DSS T-case
*DSS HD 3.5" Driveshaft
*Garrett GT-4202
*Shearer Stainless steel top mount exhaust manifold w/44mm Tial gate
*Hogan 2pc. Race intake manifold
*Custom I/C Bar & Plate
*Haltech E11v2
*MSD DIS-4 High Output
*Safegaurd-Individual Cylinder Control (Knock monitoring system)
*Weldon 2345A fuel pump (-12 from tank to pump.-10 to rail and back)
*PTE 1,600cc injectors
I'm not gonna go into specifics about the motor but I'll just say I've been machining for over 12 yrs.I run Pauter rods,JE pistons,custom spec casidium coated wrist pins,New OEM crank,O-ringed block and head.I'll just post a video.Theres too much to list.