Alright well I'm guessing the wheel cylinders are fine, because I checked for any leakage. I have been bleeding the brakes, but have only got as far as the right rear, and left rear. As soon as I started the right front, I realized I can't get the bleeder bolt off.
Does it make a difference if I didn't have the tube that I was using submerged in brake fluid? Because I just had it go into a water bottle, without submerging it. I kept the brake pressed down while tightening the bleeder bolt again.
Also, does it matter how far I press the brake down? ie: Should it be pressed all the way to the floor? (This is what I did)
And after working on the rear brakes, my brake light went OFF but still no pressure in the pedal.