Thread: 499whp 341ft-lbs on 93 octane pump gas
View Single Post
Old Sep 28, 2007 | 10:46 PM
  #1 (permalink)  
Alpha's Avatar
Alpha
Registered User
 
Joined: Jul 2002
Posts: 9,270
Likes: 0
Default 499whp 341ft-lbs on 93 octane pump gas
I will post the dyno sheet tomorrow. TheRedDragon's DA Integra made 499whp and 341ft-lbs with the dyno fan turned off Woops. This was done on 93 octane pump gas. If we have time and fuel we will dyno race gas this weekend. TheRedDragon built the bottom end, head and everything himself. Very tough motor Dyno sheet tomorrow. We're leaving now Short run down of the setup below ...

* 84mm Benson sleeved B18c1
* Stock port B16a head
* ITR cams
* 67mm turbo
* Wiseco 8.8:1 pistons (domes prepped by TheRedDragon and myself)
* Crower rods
* AEM EMS
* GM 3-bar map sensor
* AEM boost control solenoid (I love this thing)
* 1000cc fuel injectors
* Walbro 255-hp in-tank
* Walbro in-line
* NGK R5671A-10 plugs (electrode tip, not projected)
* STOCK DISTRIBUTOR, COIL ROTOR



__________________
- Induction Performance
* IP E-Mail
* IP Face Book
* IP Web-Site

* RIP Kevin/Slo_Si RIP & Pablo/Fathead
Last edited by Alpha; Sep 29, 2007 at 08:39 AM.
Reply
0