Originally Posted by
I want a 240
Dont mean to pry/bust on your car, I mean yea its clean etc etc etc BUT if its fully built exspecially sleeved why are you only running 10 lbs? And why are you loosing to a corvette w/ i/h/e, If its fully built? I know if its "Fully Built" it can push alot more then 10 lbs of boost. I dont see how this adds up, Ive scene stock LS push more then 380 to the wheels. I used AEBS-T Sleeves and with that along with my pistons/rod setup i can run over 40 lbs of boost.... Lmk
Do the math.
My car
~2100lbs
388fwhp forget torque
The C6 z06
~3200lbs
510rwhp
Now, the reason I'm on 10 psi is because I need a tune for higher, obviously. I'm going to EFI University October 15th Class for both the Basic and Advanced. So I was planning on tuning the car for 18psi when I got back. I can't afford running race gas of any mixture in this car, since I pretty much daily this car recently, alot.
Hope that answers any confusion.
Why run anything more than pump when I can barely hook, right now? It's a street car. I guess how you drive the car is what determins what you want to do with it.
Might I ask a question.
I want a 240:
Q:Have you ever been in a 400fwhp 2100lb car, before?
Also, that corvette is a 2007 C6 z06, NOT a C5.
Very, very... big difference.
10s out the box.