Looks very nice, take it easy on her. break in takes almost 2500 miles.. don't swallow this 500 miles crap, that is for a clutch..I have been building rotary engines for over 11 years now. The second engine I built was 10 years ago and this was a FD with about 400 hp...I followed this formula back then when it was given to me by Cameron the owner of Pettit Racing...

Change your oil every 300 to 500 miles what ever you can afford, until you hit around 2500 miles. Run Castrol 10-30 reqular oil, no synthetic..

Besure to run oil in the gas..You need to run 2 stroke oil, and it has to be TCW-3.. This will make sure you are getting plenty of lube and no wear during start up, when all the wear happens. It also makes power more linear when in the higher rpms, it also makes the engine run smoother while WOT...PS:run 93 octane and keep the boost low.....

Nice centerforce clutch, I have seen them grab hard while covered in engine oil...