I pulled the entire Cx harness from the motor including the o2. I've got to get a lot of tape and wire loom off the wires, even though I already pulled a lot off.

The 4 wires from the o2 (shown in the pic above) should run all the way back to the end of one (or more) the harnesses that connect to the shock tower harnesses, right?

If this is true then I just have to find the pins at the shock tower harnesses and tap in at the shock tower.

I just want to get all this cleared up before I start running more wires.....

Thanks again!

I'll post pics of the harnesses (mainly o2) once I get it unwrapped and laid out. I have to get going to work now, but am off tommorrow