Main Rom Features:

* High and low cam tables with size 24x20
* High and low load vtec window(tps based)
* Secondary maps(second set of high / low cam maps)
* High and low cam rev limiter with fuel cut/ ignition cut/ fuel and ignition cut
* Electronic boost controller(gear or rpm dependent)
* Manual dual/tri/quad stage boost controller
* Cold, hot and cut on MIL boost cut protection
* 3-Step launch control with anti-lag and tps activation
* Gear depended shift light(MIL/check engine)
* 3 General purpose outputs with fuel/ignition adjustments(or ability to switch to secondary maps)
* Injector calibration with fuel offset, overall fuel trim and battery compensation table
* Fuel trims: injector, overall, o2, tps tip-in, crank, postfuel.
* Gear based ignition and fuel corrections
* Target idle with IACV adjuster
* Closeloop(with use of wideband 0-5v signal)
* Support of different kinds of mapsensors
* Table load selectable: map sensor/ tps sensor/ alpha-n
* Selectable gearbox
* User adjustable fuel cut settings
* Use any input for Service Check Connector or use KOEO TPS(key on engine off & tps>50%)
* Ac cut and ac idle recovery
* Disable Ignition correction above X mBar

Main Software Features:

* Datalogging:
o Fast datalogging of 80 parameters
o Live Tuner graphs( time vs AFR, rpm vs AFR/Boost)
o Save logs for later analyzing, view in Grap mode
o Export to CSV
o Custom Data display
o Warning range for most parameters
o Graph templates for different type analyzing
* Realtime Updating
o Fast updating of the rom
o Upload a calibration only(less then 1 seconds)
o Upload the base code(less then 4 seconds)
* Easy to use interface
o Lots of options and data still organized
* Basemap creator
o Selectable Ecu's
o Selectable Basemaps for different engines
o Adjust mapsensor during creation
o Adjust injectors during creation
o Select amount of columns, boost fuel, boost retard
* View and clear error codes
* Automatic software updates
* Table editing
o Easy table editing
o Auto Adjust selection based on wideband reading and target afr
* Table Graphs
o 2d presentation of data
o 3d presentation of data
o Advance visual editing of tables
* Read or write chips
* eCtune uses universal calibrations which are rombase version independent
* Snapshot manager
o Make snapshots during tuning. Roll back an old calibration fast.
* Export/Import tables only
* 3 user configurable analog inputs
* 3 inputs for wideband logging
* Different predefined widebands or use custom volt to afr table
* Tools for Injector Calibration, Tps Calibration, Timing Sync, Boost Tables and Killing Injectors

and more to come....
__________________________________________________ ____________

So what is eCtune you ask ?
eCtune is an obd1 eprom editor for use with a chipped/socketed ecu like crome, neptune, hondata.

I am an authorized tuner for the system for the Tampabay area.
I have done testing on the system on & off the dyno & find it to work amazingly.
The anti-lag & 3 step features work flawless, this system allows you to adjust your launch point to any rpm dependent upon tps. I.E: You depress your gas pedal until what ever rpm you want to launch at. You then depress the gas pedal 100% and the launch limitter / antilag will engage. The feature list alone is enough description as to the capability of the software.

You can read more about eCtune on eCtune > eCtune ( DNN 4.4.1 )