Well upon replacing the intake manifolds on the camaro, i ended up dropping a razorblade down one of the oil holes in the lifter valley. So, I figured that I would leave it, seeing as I had already gotten all of the gasket off, and drop the pan once I get the car running right, which is where I went wrong.
I started her up today to see if it would still squeak (things get better over time, right??)
Well it did, I couldn't figure it out and started dropping some 80w gear oil on some of the pulleys and then it hit me.
I went to check the oil pressure gauge, and sure enough its pegged, 60psi is at about 10 o'clock and the needle was 90 degrees straight up. so my cylinders probably aren't to happy with me
Rep me for being a retard.