Complete turbo kit for mustang f/s only

--------------------------------------------------------------------------------

Here's the deal...I have a few ideas in my head right now,but I know I will not do them untill I sell some parts off the car.This is the turbo kit out of my car,and I can include the carb if wanted.

This is a b&g hotside,you can use this kit and keep your accesories.all hot side piping is black ceramic coated,even down pipe.The cold side was made by b&g also and I had them powdercoat everything white.

tial 44mm waste gate,I will include a few diffrent springs for boost psi.

presision 76mm turbo/exhaust side is ceramic coated black/compessor side is powder coated white.I was making over 600whp at 20lbs of boost,this turbo can support close to 40 lbs.

There are two tial 50mm blow off valves one on each side of the intercooler,had to do this because I had a problem with blow back through the compessor side of the turbo after the throttle plates closed.

presision intercooler good up to 900 hp,mounts right up I have all hardware.

This setup on a 306 with flatop pistons,70cc heads and my carb went 9.04 @ 154mph.

C&s specialies carb w/ extreme carb hat...

$3,600.00 w/o carb

its been down the track about 20 times.


Its off the car sitting in the garage