So I'm wondering, I have to rebuild the bottom end of my B18B, and I would like to bump compression a bit, so when I go LS/VTEC next semester, the cams will respond a little better.

Here's the question:

On my LS crank, are there any OEM piston/rod combos that will increase compression without having to have GSR/ITR pistons pressed onto LS rods?

I know the bearings on the LS are a lot wider, so I can't run straight GSR rods, but I would like to avoid having used pistons pressed onto used rods if possible.

So, LMK what you are running, or what your friends are running on B18B's only please.

-Tim