Ive touched on this in the past but never really mentioned price so here it goes.

Im trying to justify spending another couple thou on building the cats ass of flowbenches.(12 motors, velocity prof., wet flow ability, over 1000cfm at 60") I dont wish to do production porting, but I like doing it for my own experience gain and to help people who can afford the $200 per port prices. Soooo.....

If I offered top-level porting services at $25.hr would yall be intrested? I would only do this on the side,(during the off season-hopefully full time pro-stock racing next year) but consider value for the $.

Porting usally results in a minimum of 10% increase on an as cast aftermarket port and 17-18% on a stock port. Soooo....
Say 15% average gain
Average HP Before After Gain
150 172.5 22.5
200 230 30
250 287.5 37.5

Average Cost 4cyl $250+Valve Job=$400
6cyl $375+VJ=$500
8cyl $500+VJ=$750

That well under $20/hp...Pretty affordable once a combination is closed to maxed.

Dont think because your application is boosted or has NOS that you dont need porting. ALL air has to follow the sames rules, and gains on boosted applications can be exponential.

With these prices I will include full build design/advice/assistance. All customers will also have access to all my data references and literature.

So if you guys really think you could utilize this, please tell me. If the response is a dead as last time, well ill probably build it anyway.

Thanks, Matt