Oh most definitely...

The turbo, fuel pump, injectors, and DSMLink (and tuning) will all be done in one clean sweep. No way I'm going to run this 20G without those supporting mods...

...I'm just wondering where to go from there.

Also, I'm wondering if there's anything I should do to those actual parts before installing them. I'd assume cleaning them would be good, but I would like to know what is best for cleaning parts like this.

Side Note: The exhaust manifold is a stock 2g manifold with "PORTED BY JEFF'S SPEED SHOP" imprinted on the underside of the manifold. The turbo has a Mitsubishi symbol and the numbers 49179-54[90]0 on it, as well as an "A" right between the turbo inlet and the "49179-54[90]0". Does this tell anyone anything?