pics finally up first take off ya dash then pics start after that


take the screws out of the left and right side of gauge cluster then pull it away should come off without much pull


then pull up and then out the right connector in pic above^

ok this pic above is where the tach wire is it is a grey wire with a blue streak on it i used inline connectors that came with the tach worked great.

just a pic of where i put the wires down to go to the fuse box in the side

take off cover and also take the screw of the side

take out the 3 or 4 i thinks screws on bottom then pull of carefully the panel

then i showed you where it stuck the wires through the side.after that take the 2 screws out of the side of the fuse bos and in the back of the fuse box pic at bottom


take off the screw on the metal panel then pic of what to do in next pic

then put it all back together and your finished hope it looks great and works good