lift the handle from the outside, drill out the 2 rivets that you will see, reomve your door panel, remove old handle, replace with new handle, but make sure you place the rod on to the the new handle, and now you can either rivet the new handles on, with a large rivet gun, not the usual one you buy in the parts store, it needs a larger one, or you can do what I usually do, and use a panhead bolt and a locking star washer with a nylon sleeved nut. Replace the door panel and stand back check out the work and Badda boom, your done. Anything out on the market is better than the stock crappy ass aluminum, alot of the handles now are stamped steel, so they should last a bit longer. But if they dont, again there easy to replace. Good Luck.