Originally Posted by NoTLaDStyle
on the same amp, no. It will off balance the output signal which for some reason will damage the amp over time.
I beleive this is only true for L&R channels, the front and rears are totally separate circuits so you can probably run 2ohm stereo on the front two and 4ohm briged on the rear two
wait, what? I'm planning on running one channel up to the front two and the other channel to the rear two..
i guess i'll just run four ohms on all of them, luckily the amp has 200x2 on 4ohms anyways so i wont be falling short on power or anything.