Ok guys heres an update.. yesturday I got new Plugs, Wires, and an ignition switch. I got the ignition switch in so the car will turn on and stay on now, and I changed the Plugs and wires. There are still a few problems tho. First, mad smoke. Like.. lots and lots of smoke. Nothing horrific.. but its bad enough. Also, we got the car running and left it on for a while.. say about 10 minutes or so. No overheating.. so we took it up the street to see how it would run. When I turn left there`s a scraping noise. Not crankwalk cuz Its not that serious. Sounds like more of a problem with maybe the rotors or something. Anyways, we took the car back up to the house and as we were coming up into the driveway, the car stalls out. I try to turn it back on and its VERY hesitant. I had to pump the gas just to get the car to turn on.. but then if I let up off the gas the car stalls. RPMs were at about 200 at this point. Finally I turned the car back on and left it at 2000 RPMs and got it into the driveway. We left the car on and it sounds like its misfiring. I dont understand because we just changed the plugs and the wires. Everything was in good but my friend who was helpin me told me it may be an electrical problem. The RPMs jump too erratically. He told me it may be one or more of four things. 1) Bad ECU 2) Crank Sensor 3) Coil Pack 4) Power Transistor.

Not too sure whats going on here but any help would be appreciated. Thanx again guys. =]