Thread: I want B16
View Single Post
Old May 7, 2006 | 05:41 PM
  #4 (permalink)  
Redlineboyzcrx's Avatar
Redlineboyzcrx
RHD ITR
 
Joined: May 2006
Posts: 585
Likes: 0
Default

Alright, here are the specs on my car, and a few pics.

If I am going to trade, I would like to trade for a 92-95 Civic Hatchback. Let me know if you have a civic hatch.

This car runs Low 13's, capable of high 12's with tuning.



Engine:
JDM B16a SiR Swap
AZ Race Motor Mounts
B&M Fuel Pressure Regulator
Crane Cams Ignition Wires
ITR Throttle Body
Koyo Racing Radiator
RS Akimoto Intake
Skunk 2 Short Shifter
Tanabe Racing Medallion Exhaust

Head:
3 Angle Valve Job
CTR Cams
Hondata Intake Manifold Gasket
KMS Silicon Bronze Valve Guides
OmniPower Titanium Retainers
Port & Polish
Port Matched
Skunk 2 Dual Valve Springs
SuperTech Racing Valves
STR Pro Series Cam Gears
Type-R Valve Cover

Block:
King Performance Racing Main Bearings
King Performance Racing Rod Bearings
CTR N1 Crank Pulley
CTR Pistons


Transmission:
S1 Tranny
ACT Clutch
Fidanza Aluminum 7.5lb Flywheel

Suspension:
Drop Zone Camber Kit
Rear Tie Bar
Rear Strut Bar
Skunk 2 Coilovers
Titan Tower Strut Bar
Tociko HP Shocks

Electronics:
Apexi VAFC 2
Kenji Chipped & Socketed ECU
RyWire Engine Wiring Harness


[/]Interior:[/B]
Autometer 5" Tach
Momo Steering Wheel
Memphis 5 1/4" Speakers
Rockford Fosgate 6X9 Speakers
Sparco Race Pedals
Sony Head Unit

Exterior:
Fiberglass Hood
JDM Taillights
Motegi MR7 Rims
Mugen Bodykit

1-386-503-1611
Reply