ummm.

I'd have to look. i had the case bored for the 1040 kit, all new seals and guides put in. which were only a few $ each but i have a 5 valve per cyl head so it added up fast in parts. with cleaning and checking for cracks. i paid around 600 total. about 250 in just the head.

but i also pulled the motor and just droped off the head and cyl case. I'm into the whole rebuild for about 1300$ with the pistons, gaskets and little shit.

i say call chad like above but if you want to, give rtm a call too. that's where i had my stuff done. mostly cause its close to my house and didn't feel like driving out to kinetic. but i will say i like kinetic better the time i was out there.