I just realized that my car hasnt been reading a map signal this whole time.... Now, i checked all the pins, wires, everything. Everything is good. Except the funny thing, the car runs without the map signal wire connected. Oh yea, and I have the .bin set to utilize the map sensor. So in crome, the box for map is UNCHECKED, meaning my car should be reading it. I found that the map cutoff threshold was at 114 mbar, i changed it to 1734 mbar. I thought that would fix the problem, but it didnt. I want to use my vafc II in my car but everytime I hook up the CUT map wire to run throught the afc, the car wont run. It reeevs to like 3 grand or lower for a couple seconds, then dies. If i press the gas it dies even quicker.

I need my map sensor to work badly, I also need my vafc to function correctly.... Can anyone help analyze the problem? Maybe its the ecu? The check engine light doesnt come on with the map enabled or disabled.

I have chipped p06 on the 1720 board. Using crome. Stock map sensor. 91 integra obd converted. If youve heard of this or experienced this problem before please let me know!