I am building an ls/vtec set up for my crx. I want to know if .25mm oversized p30 pistons (jdm b16) will fit on ls rods. Also, does anybody know of a good machine shop that will hone my cylinders,plug the head and tap my block for the knock sensor for a reasonable fee. So far these are the parts that I have for my set up.
First gen b16 head (stock), harness,pr3 ecu,injectors,distributor. 96 b18b1 short block,ls rods,ls crankshaft (very good condition). ARP rod bolts,ARP head studs, Golden Eagle ls/vtec kit,gsr water pump,gsr oil pump,gsr timing belt. I still have to measure oil clearances on the rod bearings and the main bearings.