i currently have a clutch masters stage 4 6 puck un sprung in my hatch, it has been attatched to that block for over 2 years. it works great for what i do with it and it holds the power well. it only took about a day to get use to it and its cake from there on out. this is my first CM tho. i have always run ACTs in my cars, there is a downfall to ACT tho, there pressure plates are usually SO strong that they rock trannys to death, especially in under powered cars and from people power shifting the crap out of them.

i have also used clutchnet before and they are a piece of crap with bad customer service.

on a side note: i have had 3 bad pressure plates from ACT, by that i mean, the pressure plate was assembled wrong and WOULD NOT disengage, it was an assembly issue and they sent me new ones