yep, just what it says, I have my 95 for sale to finance the last bit I need to finish my 98, anyway, like it says its a DOHC 5 speed Coupe, with R/T wheels, however it does need some work....it needs new shocks and springs since the previous owner cut these ones and blew out the shocks, it will need new tires soon because the alignment was thrown out of wack from the aforementioned spring cutting and has caused premature wear on these(they are Falken tires btw) it also needs new dash pieces due to the airbags deploying when the previous owner ran over a curb(yeah I know, I hate the previous owner too) anyway, now for the good stuff, the car runs fine, has something over 100K miles, the car comes with a 2.4L block from a 96 sebring, along with my 8.5:1 compression Wiseco pistons on Turbo 2 rods that have been machined to fit the 2.4L block(the pistons alone are worth about $400) one of the rods will need to be resized due to a spun rod bearing and a new crank will need to be gotten for the block due to scratches caused by the spun rod bearing I threw the old crank away, btw if you decide to use the Turbo 2 rods(which are forged btw and good to 550HP or so) you will need to use Turbo 2 rod bearings, anyway...also included is my ported and polished head from the sebring as well with a 3 angle valve job and stainless steel vlaves(it will need a couple holes retapped though for an m7 bolt due to me stupidly overtorquing once and stripping the m6 hole out, anyway, this head has $1000+ worth of work done to it and would cost less than $100 to fix perfectly, you could do it for free if you had a tap and die kit, anyway...for the entire package of car+head+block I am asking $1200...and here's a pic since I am finally able to upload again