Originally Posted by Fordified
If its creeping with no spring in the gate I'd say it can only be a few issues:
Gate is too small
Exhaust path after the gate is restrictive, not allowing the gate to flow enough.
Poor gate location. Is the gate bleeding off of 1 cylinder? Is the gate exit 90 degrees to exhaust flow?
Downpipe is restrictive.
OUTSTANDING!
A fresh set of eyes
Could there be an obstruction on the exhaust side of the housing interupting the flow of air to the waste gate?
Take a look at the bend out of the exhaust.... does it look suspecious(sp) to you?
Here's a pic of the set-up:
