Hmmm... Well, my car seems to run fine however it does need a few things and will be getting a few upgrades.

It needs one Valve stem seal. It also is running very hot on the Geo radiator, so I have a Griffin drag radiator to install.

The car is also getting some nitrous installed along with a 7cm housing that a 16g will soon reside in.

I also need to weld a small nipple on my intake tube to connect to the valve cover/crankcase vent/pcv.

In the mean time, I have a set of forged pistons and rods, new bearings, oil pump and water pump. This new motor will be assembled right after I but a damn trailer.