Once agiain, sorry partner, unless your trying to say that if you chip an auto ecu with a simple chip, harness, 28 pin female, and a another chip, and additional resistor/jumper situation, as well as a few caps, that it works,I call BS. sorry your full of it, try it once and get back w/me. no direct slamming here, but if you know your simply re-writting a eeprom 29c256 chip in a standard config manuelobd0-1-2 chipping config, you would know the res underneith the rom are different compared to a manuel.

End of story. Unless you wanna compare bordes. Im game.. Are you?
I spent 3 days conf differnt options, per diagram, no difference, once I changed it, stock eeprom, with the deal i mentioned above, stock platform, just happen ( due to some special redneck ferry ducy) to change it from a auto to a manuel,

Any way I await your responce.. hopefully Ill hear from you.

Cole

So Intailed you took a auto P28/P72, chipped it added one chip, added 2 caps changed 2 resistors and you were good? Hummmmmmmmmmmmmmmmm.......

How about the fact that a stock p28 has the same ... Fuck it..