**94-95 LS BLOCK** I was building this for lsvtec but change of plans.


*Brand new pr3 pistons installed on ls rods which are shotpeend with new wrist pins. All installed from Engine lab.

*Decked, Bored and Honed, pressure tested(Hot tanked) All work done by engine lab.

*Full bottom end rotating assembly balanced (Full race balance) Also done by engine lab of tampa.

*LS crank micropolsihed and balanced.

*Block needs oil pan,oil pickup, tensioner,(I might have a extra oil pan laying around for it) Water pump and oil pump also for this to be a complete bottom end with the exception of alternator, bracket. Has Thermostat, water pipe,new o rings, and dowl pins. New thermostat housing and thermostat and sensors.

*Bottom end is assembled, but I would recomend if you wanted to go with oem bearings. I was using generic bearings from napa. Which will work, but its up to your personal prefernce.

Iam selling cheap to put the motor iam building (another one) which is cheaper project towards my new build. Block is clean and done right.

$600.00 obo. Make some resonable offers I will consider it.

**Comes also with a free engine stand.