well afte rhaving much time on my hand and saving loads of $$$ over here in Asia i have been ordering many many many parts for the old mootang! and i just ordered the last round till i get home(12 days).

here is the mods before i left:
O/R H-pipe
Magnapack Cat-back
Steeda Tri-ax
Steeda rear drag springs w/air bag
Steeda rear lower aluminum control arms
75mm TB
BBk CAI
predator tuner w/custom tune thanks to Sam@Coastal
75 dry shot from Compucar

that netted a 307/365ft lbs on the Dyno.....

now for the list of parts sitting in my apartment that will be installed within the next few weeks:

Weld Racing Draglite 15x3.5 with 165R rubber
Weld Racing Draglite 15x10 with 26.5x10x15 ET Streets
Steeda Dbl. Adj. rear upper control arms
Steeda full length sub-frames
Steeda front drag springs
Strange 10-way rear shocks
Metco DS loop
FRPP 4:10's
Mac 1 5/8" ceramic coated long tubes
Mac Pro-chamber
C&L upper plenum
C&L 85mm MAF
C&L true flow pipe
24lb injectors
UPR intake spacer/nitrous plate
Comp cams XE262ah
Comp Bee Hive valve springs
Diablo Sport flip-chip
and of course taking the shot up to a 100 or maybe a 125 wet if i can find the right kit.

so, any horsepower predictions? 1/4 times?

EDIT: once i return home i will lay out all the parts and take a picture of all of them laying on the floor. also will be updating this forum along with my fellow N2S members with pictures of the install process.