its easy. Trust me. Just get what you need to remove what is in your way. Its right there
up top. Ive never done one in a car though. Its always been before the motor was installed.

When installing I know must people arrue of this. But the water pump already has a gasket. You can in my case, just run some RTV or some Hondabond around the inner plate. Right above the rubber gaket inside the new water pump. Its up to you. You can just put it on and bolt in down. Or use the rtv.

Another thing. Those bolts will break easy. Just tighten them down to where they are good. Do not go more then when it feels like the bolt is going to break. Just be careful cause you don't want to break those bolts.