i posted this before for him under his original thread, i was told this is what ya need. it sounds bout right to me


Parts needed:
14b
1g J-pipe
2g LICP
10" x 2" pipe (with beads welded at ends)
2g oil feed line (oil filter side)
1g oil feed line (turbo side)
1g or 2g drain pipe
1g or 2g water lines (bending needed)
Rubber fuel injection line
High-temp Copper/Silicone gasket maker

Total cost of install kit: $40


1. Cut the 2g LICP inbetween the two 90* bends
2. use 10" long pipe to raise LICP to the 1g J-pipe
3. cut 2g oil feed line near turbo
4. cut 1g oil feed line near the already cut 2g line
5. connect the two feed lines using fuel injection hose
6. install water lines, bend as needed
7. use gasket maker in place of mani->turbo, turbo->o2 housing, o2 housing->downpipe gaskets.