Ok smart guy..here goes:

I wasn't driving like a dumbass, it was a narrow backroad, and the oncoming car was taking up more than his lane's worth as always and I was pulling off the side to avoid him last second as it was a blind corner, my mother wasn't upset at all with what happened since it was an accident.

The car, it is not built, it's a fucking rb..aka race built. All internals are stock, people can get 500whp from them stock internals.

The turbo is a t3/to4e 57 trim compressor with .63 stage 3 turbine with external tial 38mm gate. It doesn't get full 18 psi until 4500 rpms. I have a Fidanza 11lb flywheel, and XTD heavy duty clutch. The injectors are from a series 5 89 RX7 Turbo II and are 550cc's. I have a z32 maf with stainless mesh air filter since the RB20 maf only handles 300hp. I custom made the intake manifold myself out of a roadsign. The intercooler setup is a full Hybrid brand setup with piping modified to fit my setup, it's 2.5" pre intercooler and 2.75" after. For engine management I'm using an Intronics Romulator emulator that takes place of the eprom chip that is normally there. I'm using LiveEdit version 2.2 to program the ecu in realtime and I use a techedge wideband to do the tuning with. On top of that I have a 3" downpipe with a McCord power plate which is an electronic exhaust cutout which I can open up in a couple seconds to get maximum power whenever I want. I have a manual boost controller, and Apexi Multichecker to keep an eye on the vitals. That's just what's under the hood pretty much..if you'd like the rest of the mod list for the car then I can email it to you but I don't really feel like it.

Here's a pic of my engine bay:
http://memimage.cardomain.net/member...27_64_full.jpg

The emulator:
http://memimage.cardomain.net/member...27_66_full.jpg

Nick