no, the firewall badge was missing when we got it... stupid cubans with fake jamaican accents...

Ian... ive got the Driver side mud flap, the driverside fender trim w/ the Euro marker lens and the driverside rear tail light moulding that has half of a "Limited" badge still stuck to it... thats all i really had as far as trim. the passengerside mud flap was bent and torn so i ddidnt think youd want it.

i removed EVERY thing from the clip, even the firewall, so someone can take all this and physically make a RHD supra.... right down to the hood release cable and trunk/gas door release levers.

i ended up cutting the car down the middle to fit it in the U-haul pickup. ill get some pics.

heres what the "kit" includes;
89+ subframe with round mounts and anti-sway bar attached
Steering rack
Fire wall with bolt holes and flanges for accelerator, brake, clutch, steering column, dead pedal, etc.
Power brake assy with master cyl, booster, pedal, linkage, vacc pipe with 1-way check valve and light switch
Heater core vacuum valve w/ VSV
Accelerator pedal
Speedo cable
Wiper motor with wiper linkages and pivots
Various junction blocks if you so choose to keep all the electrical stuffs
Dashboard cross-brace (big metal bar)
Dashboard (gray) with center console brackets (mounts to driveshaft tunnel)
Dash wiring harness (cut in several places, i will try to put it back together)
Hood latch and bracket with release cable
Trunk and gas door release levers and bracket
Steering column with turn signal stalk, wiper stalk and ignition key (you keep your steering wheel)
Lower trim piece with Dimmer rheostat, sunroof switch and something else

dont have;
glove box or liner; it was broken when i got it
center console/HVAC/STereo trim piece
Stereo
HVAC controls
HVAC center vents
Heater core/box and ducting
AC core/box and ducting
Under-dash panel to cover steering column

i know someone could make use of this... i would do it but the supras i have right now are too cherry to mess up, plus one is going up for sale as soon as its done. ive got other priorities before i can build a RHD car... i was wanting to do it to an 86.5 Hard top Sport and gut the rest of it... make it a bad ass Drift car... but, again, i gotta build 2 7M's first, and install those brake lines, completely redo the brakes on both DSM's, and look into ordering that Soarer from japan.