when you are getting ready to put the cams back in make sure you clean the piss out of the cam bolt and camshaft threads. then after all the threads are clean of dirt, sand, and oil (i mean take your time on this, it cost me a motor) then put blue loctite on the cam gear bolt. bolt down the cam and torque the cam gear bolt to 140 ft-lbs. making sure your gears and chain are dead on cause if not youll have to do it all over again.
the loctite takes 20 min to set and 24 hours to cure.
the cam shaft retainer bolts get torqued down to 8 ft-lbs, but make sure all the retainers are basically touching the head before you start torqueing them.
i found the hard way that its better to be safe than sorry.
__________________
If you have three quarters, four dimes, and four pennies, you have $1.19. You also have the largest amount of money in coins without being able to make change for a dollar.
