I am not doing this for an all motor setup, I am going turbo on my b16 that is in the crx right now, but If you check the thread that is mentioned in my sig then you'll fully understand.

the b16 block is blown and the cylinder wall has about a 1inch by 2 inch chunk missing from 1 cylinder, the head is from a b18 and has several internal parts missing. I just need the shape to be a bseries motor so I can have an engine on a stand to fab up my new idea on a turbo setup. but thanks all for the info and if anyone knows more then feel free.

I just basically need to know that the head will bolt to the block without haveing to tap a new bolt hole and that everything will line up as if it were a b16 setup.