it is plug and play if you mean you can plug it in and play with everything till you get it right. there are several wires that need to be swapped around within each plug and there are 2 wires, 1 from each plug, that need to be swapped from 1 plug to the other. I will try to see if I can find the notes from my swap but I looked at the circuit path and traced it by hand to see where each one goes and drew up my own pin out diagram for both clusters then swapped the pins to where they needed to be.

this can be a hard way to go if you don't understand electronics and electrical flow, given that there are several indicator lights that have a common connection and then seperate triggers as well as a few diodes in the set up.