Thread: Solid roller???
View Single Post
Old Apr 29, 2004 | 07:23 PM
  #17 (permalink)  
Scott
Guest
 
Posts: n/a
Default Re: Solid roller???
Originally posted by HybridSS
Damn right!
7500 rpms and three stages of juice
Will work very well with the manual tranny. Im thinking it may give me a bit more breathing room on shifting.

The extra rpm range will give me more time in first gear after launch to get my shit together hopefully, and bang second. And it will extend my MPH with the current 4.11 rear gears and 28 inch tires to around 150+ mph in 4th gear.
With the hyd cam previously I was going to top out at 142 or so.
This will be a much better combo

I am thinking three stages at 3000/4600/6400 and spin to 7500 total. Probably around 100 shot on each. Of course the motor will be around 475-500 hp NA this time around.
by my calculations if I can make the same 700 ft/lbs the motor was making before at 6500 rpms that will be roughly 860 rwhp with a VERY broad Tq band from 3200 rpm to 7300 rpm. Want atleast 600 ft/lbs in that range.

Sounds good on paper....we will see


You won't !
Reply
0